Sony VPL-HW55ES Operating Instructions - Page 24
Connecting to a 3D Sync Transmitter, CAUTION - glasses
View all Sony VPL-HW55ES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Connecting to a 3D Sync Transmitter This unit incorporates a 3D Sync Transmitter. Depending on the installation environment of the unit, the 3D glasses may not receive 3D signals properly from the unit's built-in 3D Sync Transmitter. In this case, connect an optional 3D Sync Transmitter and place it near your viewing position. Right side of the projector 3D Sync Transmitter (not supplied) Connecting cable : 3D sync signal flow Tip Place the optional 3D Sync Transmitter directly facing the 3D glasses. Also, in order to stabilize operation of the 3D glasses, it is recommended that you place the 3D Sync Transmitter near your viewing position. CAUTION Be sure to use straight-type LAN cable of up to 15 m labeled TYPE CM, and do not use an extension cord. Notes • The 3D SYNC connector is dedicated for the optional 3D Sync Transmitter. Do not connect computers or other network devices, to avoid malfunction. • You can use a 3D Sync Transmitter separate from this unit, using an optional LAN cable (straight- type). If the usage environment has interference of a continuous specific frequency, synchronization of 3D image signals and the 3D glasses may be lost. In this case, use a LAN cable labeled Category 7. When watching 3D images in an environment that has even more interference, use the internal transmitter. • Be sure to use cable of up to 15 m, and do not use an extension cord. Also, keep the LAN cable away from any AC power cords as much as possible. • Only one 3D Sync Transmitter should be connected to the unit. Connecting multiple 3D Sync Transmitters may cause a malfunction. • When connected to the 3D Sync Transmitter, the built-in 3D Sync Transmitter feature of the unit will turn off. You cannot use both at the same time. GB 24