Sony XAV-7W Installation Instructions - Page 5

1 Installing the Main Unit Installation angle The unit should be installed within an angle of 25 degrees from horizontal. If this angle is exceeded, the monitor may not open up or retract properly. Before installation This unit is designed to be completely safe, but if not installed correctly, it can cause accidents. Be sure to verify the following points before installation. Install the main unit to the in-dash location, and the connection box under the navigator's seat, etc. • If the monitor in the opened position is close to a air- conditioning outlet, the outlet should be closed. • Install the unit so that the monitor when opened up will not block access to the hazard switch or other important controls. • Do not install the unit (monitor) in locations which may be subject to excessively low or high temperatures. (Otherwise the unit may be deformed and the LCD may be damaged.) Exposure to direct sunlight can also lead to high temperatures and should be avoided. Note Keep the units and connection cables apart. The Media Center main unit and the connection box 1 should not be in close proximity. Selecting the installation location 1 Set the ignition key to OFF or remove it. 2 Place the units in their intended mounting locations to check the cable length and monitor installation conditions. 5