Sony XBR-55HX929 Setup Guide (Operating Instructions) - Page 26

Programming the Remote Control (For RM-YD057 and RM-YD067 remote control users) Your remote control can be programmed to use other equipment and is pre-programmed to operate the following Sony equipment. Function Button Sony Equipment Code Number DVD DVD Player 31033 AMP Receiver 52172 STB Digital Satellite 01639 Programming Other Equipment Follow the steps below to program your TV remote control. 2 1 Look for the code in the Manufacturer's Code List (refer to 2 i-Manual) that corresponds to the equipment you would like to operate with the Sony remote control. If more than one code is provided, try programming the first code listed. If your equipment's code is not listed, visit 4 http://esupport.sony.com/remotecodes for a more comprehensive list. 2 Press and hold DVD, AMP or STB function button simultaneously with t button and release. 3 When in the programming mode, the function button (DVD, AMP, STB) blinks for approximately 30 seconds until a code is entered. 3 Enter the five digit code using - while the function buttons (DVD, AMP, STB) are lit. If the code is not entered within 30 seconds, you must repeat step 2. 4 Press to confirm the code. If successfully programmed, the function button (DVD, AMP, STB) will blink twice, if not, it blinks five times. Confirm the Programming If you can turn your equipment on and off using the green POWER button, the programming is complete. If not, try the next code listed. ~ • In some cases, you may not be able to program your remote control. If this is the case, use your equipment's own remote control. • Any of the function buttons (DVD, AMP, STB) can be programmed to operate other equipment regardless of the labeling. For example, if programmed with the correct code, a Blu-ray Disc player can be operated with the DVD button. This is useful if your equipment does not match any of the labeled buttons. To reset the remote control to the factory default: Press SCENE, TV "/1 (TV POWER), and simultaneously. The four function buttons (DVD, AMP, STB, and TV) blink when successfully reset. 26