Sony XBR-55X900A Operating Instructions (Setup Guide) - Page 11
: Connecting the TV, Detaching the Table-Top, Stand from the TV - hdmi 2 0
View all Sony XBR-55X900A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Getting Started ~ • If using an electric screwdriver, set the torque at approximately 1.5 N·m {15 kgf·cm}. 3 Attach the under cover. 1 2 2: Connecting the TV ~ • Use an antenna cable connector no greater than 14 mm thick. • Use an HDMI cable connector within 12 mm (thickness) × 21 mm (width). • Use Sony HDMI cable with "High Speed" indication for HDMI connection. • For more information on connections, refer to the i-Manual. x Shown with a Set Top Box with HDMI connection 3 Detaching the Table-Top Stand from the TV To detach the Table-Top Stand from the TV, remove the screws fixed in step 2. ~ • Do not remove the Table-Top Stand for any reason other than to install corresponding accessories on the TV. • Be sure the TV is vertical before turning on. To avoid uneven picture uniformity do not power on the TV with the LCD panel facing down. • When installing the TV on a wall, remove the screws from the rear of the TV. Be sure to store the removed screws in a safe place, keeping them away from children. • When attaching the Table-Top Stand again, be sure to fasten the screws (previously removed) to the original holes on the rear of the TV. Set Top Box (Continued) 11