Sony XSP-N1BT Operating Instructions - Page 25
Radio reception, CD playback, NFC function, BLUETOOTH function
View all Sony XSP-N1BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
The smartphone connected via a USB cable does not charge. Make sure that the cable is connected correctly. Set [CHARGE] to [CHARGE STD] (page 17). Radio reception Stations cannot be received. The sound is hampered by noises. The connection is not correct. If your car has built-in radio antenna (aerial) in the rear/side glass, connect an REM OUT lead (blue/white striped) or accessory power supply lead (red) to the power supply lead of a car's antenna (aerial) booster. Check the connection of the car antenna (aerial). If the auto antenna (aerial) will not extend, check the connection of the power antenna (aerial) control lead. Preset tuning is not possible. The broadcast signal is too weak. RDS PTY displays The current station is not an RDS station. RDS data has not been received. The station does not specify the program type. CD playback The disc does not play back. Defective or dirty disc. The CD-R/CD-RW is not for audio use (page 20). MP3/WMA files cannot be played back. The disc is incompatible with the MP3/WMA format and version. For details on playable discs and formats, visit the support site. MP3/WMA files take longer to play back than others. The following discs take a longer time to start playback. A disc recorded with a complicated tree structure. A disc recorded in Multi Session. A disc to which data can be added. The sound skips. Defective or dirty disc. USB playback You cannot play back items via a USB hub. This unit cannot recognize USB devices via a USB hub. A USB device takes longer to play back. The USB device contains files with a complicated tree structure. The sound is intermittent. The sound may be intermittent at a high-bit-rate of more than 320 kbps. Pandora® connection is not possible. Shut down the Pandora® application on the mobile device, and then launch it again. Application name is mismatched with the actual application in App Remote. Launch the application again from the "App Remote" application. NFC function One touch connection (NFC) is not possible. If the smartphone does not respond to the touching. Check that the NFC function of the smartphone is turned on. Move the N-Mark part of the smartphone closer to the N-Mark part on this unit. If the smartphone is in a case, remove it. NFC receiving sensitivity depends on the device. If One touch connection with the smartphone fails several times, make BLUETOOTH connection manually. BLUETOOTH function The connecting device cannot detect this unit. Before the pairing is made, set this unit to pairing standby mode. While connected to a BLUETOOTH device, this unit cannot be detected from another device. Disconnect the current connection and search for this unit from another device. When the device pairing is made, set the BLUETOOTH signal output to on (page 8). Connection is not possible. The connection is controlled from one side (this unit or BLUETOOTH device), but not both. Connect to this unit from a BLUETOOTH device or vice versa. The name of the detected device does not appear. Depending on the status of the other device, it may not be possible to obtain the name. No ringtone. Adjust the volume by pressing VOL +/- while receiving a call. Depending on the connecting device, the ringtone may not be sent properly. Set [RINGTONE] to [1] (page 19). 25GB