Soundcore Liberty Air 2 Pro Manual - Page 8
Reset
View all Soundcore Liberty Air 2 Pro manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Mono mode Play/Pause Answer a call Tap twice End/Reject a call Activate Siri or other voice assistant software Press and hold for 2 seconds • All of the controls in stereo mode can be customized in the Soundcore app. In mono mode, controls cannot be customized in the app. • Music playback will auto-pause when removing the earbuds, wear them again to resume. • Adjust the volume level via the connected device or in the Soundcore app. • In stereo mode, noise cancellation mode is set by default. Each time you power on and connect, or switch to the stereo mode from mono mode, your earbuds will restore the last setting. • Noise cancellation or transparency mode is unavailable in mono mode. Reset You might need to reset your earbuds if you experience any connectivity problems or function issues. 1. Place the earbuds in the charging case and leave the case open. 2. Press and hold the button on the case for 10 seconds until the earbud LED indicators flash red 3 times and then turn white. 3. Wait until the LED indicator on one of the earbuds flashes fast while the other breathes slowly. This confirms that the reset was successful and your earbuds can be connected normally. 1 2 3 3 10" The following two examples indicate the reset has not been successful and the previous steps should be repeated. EN 06