Stihl BT 130 Earth Ice Auger Product Instruction Manual - Page 8
Before Starting, WARNING, Auger Brake, Starting
View all Stihl BT 130 Earth Ice Auger manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
English Before Starting WARNING Always check your power tool for proper condition and operation before starting, particularly the throttle trigger, throttle trigger lockout, slide control, drilling tool and auger brake. The throttle trigger must move freely and always spring back to the idle position. Never attempt to modify the controls or safety devices. Regular maintenance is important in this respect. Make sure the drilling tool is in good condition and properly connected. WARNING Check fuel system for leaks, especially the visible parts, e.g., filler cap, hose connections, manual fuel pump (only for power tools equipped with a manual fuel pump). Do not start the engine if there are leaks or damage - risk of fire! Have the machine repaired by a servicing dealer before using it. WARNING Never operate your power tool if it is damaged, improperly adjusted or maintained, or not completely or securely assembled. WARNING Check that the spark plug boot is securely mounted on the spark plug - a loose boot may cause arcing that could ignite combustible fumes and cause a fire. Keep the handles clean and dry at all times; it is particularly important to keep them free of moisture, pitch, oil, fuel mix, grease or resin in order for you to maintain a firm grip and properly control your power tool. Auger Brake Your earth auger model is equipped with an auger brake, which is designed to reduce the risk of injury from reactive forces by stopping the rotation of the auger / powerhead when the brake activating lever is engaged. It should also be used during starting and when unwinding a trapped auger. See the chapter on "Auger Brake" for information on engagement of the brake. Starting Start the engine at least 10 feet (3 m) from the fueling spot, outdoors only. For specific starting instructions, see the appropriate section of your manual. Place the power tool on firm ground or 9912BA013 KN other solid surface in an open area. Maintain good balance and secure footing. WARNING Your earth auger should be started only when it is held steady by the operator. WARNING To reduce the risk of loss of control, be sure that the auger brake is engaged. When the engine starts at starting throttle, engine speed will be fast enough for the clutch to engage and, if the auger brake is not engaged, turn the drilling tool. Once the engine has started, immediately blip the throttle trigger, which should release the starting throttle and allow the engine to slow down to idle speed. WARNING Your power tool is a one-person machine. Do not allow other persons in the general work area, even when starting. WARNING When you pull the starter grip, do not wrap the starter rope around your hand. Do not let the grip snap back, but guide the starter rope to rewind it properly. Failure to follow this procedure may result in injury to your hand or fingers and may damage the starter mechanism. 6 BT 130