Stihl FS 46 Product Instruction Manual - Page 30
Rewind Starter, Storing the Machine, Replacing Nylon Line
View all Stihl FS 46 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
English Rewind Starter Storing the Machine Replacing Nylon Line To help prolong the wear life of the starter rope, observe the following points: N Pull the starter rope only in the direction specified. N Do not pull the rope over the edge of the guide bushing. N Do not pull out the rope more than specified. N Do not allow the starter grip to snap back, guide it back into the housing slowly - see chapter on "Starting / Stopping the Engine." Have a damaged starter rope replaced by your dealer before it breaks completely. STIHL recommends that you have servicing and repair work carried out exclusively by an authorized STIHL servicing dealer. For periods of 3 months or longer N Drain and clean the fuel tank in a well ventilated area. N Dispose of fuel properly in accordance with local environmental requirements. N Run the engine until the carburetor is dry - this helps prevent the carburetor diaphragms sticking together. N Remove, clean and inspect the cutting attachment. N Thoroughly clean the machine - pay special attention to the cylinder fins and air filter. N Store the machine in a dry and secure location - out of the reach of children and other unauthorized persons. STIHL AutoCut C 5-2 Always check the mowing head for signs of wear before replacing the nylon line. If there are signs of serious wear, replace the complete mowing head. Preparations N Shut off the engine. N Put the machine on the ground with the mowing head facing up. Disassembling the mowing head and removing remaining nylon line In normal operation, the supply of nylon line in the head is used up completely. 28 FS 45, FS 46