Stihl FS 56 RC-E Product Instruction Manual - Page 26

English Removing the metal cutting blade N Block the output shaft N Unscrew the mounting nut clockwise. N Take the parts off the shaft - do not remove the thrust plate (5). Fuel This engine is certified to operate on unleaded gasoline and the STIHL twostroke engine oil at a mix ratio of 50:1. Your engine requires a mixture of highquality gasoline and two-stroke air cooled engine oil. Use mid-grade unleaded gasoline with a minimum octane rating of 89 (R+M/2) and no more than 10% ethanol content. Fuel with a lower octane rating may increase engine temperatures. This, in turn, increases the risk of piston seizure and damage to the engine. The chemical composition of the fuel is also important. Some fuel additives not only detrimentally affect elastomers (carburetor diaphragms, oil seals, fuel lines, etc.), but magnesium castings and catalytic converters as well. This could cause running problems or even damage the engine. For this reason STIHL recommends that you use only high-quality unleaded gasoline! Gasoline with an ethanol content of more than 10% can cause running problems and major damage in engines with a manually adjustable carburetor and should not be used in such engines. The ethanol content in gasoline affects engine running speed - it may be necessary to readjust the carburetor if you use fuels with various ethanol contents. Warning! To reduce the risk of personal injury from loss of control and / or contact with the running cutting tool, do not use your unit with incorrect idle adjustment. At correct idle speed, the cutting tool should not move. If your power tool shows an incorrect idle adjustment, have your STIHL dealer check your power tool and make proper adjustments and repairs. The idle speed and maximum speed of the engine change if you switch from a fuel with a certain ethanol content to another fuel with a much higher or lower ethanol content. This problem can be avoided by always using fuel with the same ethanol content. Use only STIHL two-stroke engine oil or equivalent high-quality two-stroke engine oils that are designed for use only in air cooled two-cycle engines. We recommend STIHL HP Ultra 2-Cycle Engine Oil since it is specially formulated for use in STIHL engines. Do not use BIA or TCW rated (twostroke water cooled) mix oils or other mix oils that state they are for use in both water cooled and air cooled engines (e.g., outboard motors, snowmobiles, chain saws, mopeds, etc.). Take care when handling gasoline. Avoid direct contact with the skin and avoid inhaling fuel vapor. When filling at the pump, first remove the container from your vehicle and place the container on the ground before filling. To reduce the risk of sparks from static 24 FS 56, FS 56 R, FS 56 C, FS 56 RC