Stihl HLA 85 Instruction Manual - Page 33

Charge Times AL 100 with AP 80: - up to 80 % capacity: 70 min - up to 100 % capacity: 100 min with AP 115: - up to 80 % capacity: 110 min - up to 100 % capacity: 140 min with AP 160: - up to 80 % capacity: 150 min - up to 100 % capacity: 165 min with AP 180: - up to 80 % capacity: 160 min - up to 100 % capacity: 210 min AL 300 with AP 80: - up to 80 % capacity: 25 min - up to 100 % capacity: 50 min with AP 115: - up to 80 % capacity: 25 min - up to 100 % capacity: 55 min with AP 160: - up to 80 % capacity: 35 min - up to 100 % capacity: 60 min with AP 180: - up to 80 % capacity: 40 min - up to 100 % capacity: 70 min AL 500 with AP 80: - up to 80 % capacity: 25 min - up to 100 % capacity: 50 min with AP 115: - up to 80 % capacity: 20 min - up to 100 % capacity: 25 min with AP 160: - up to 80 % capacity: 35 min - up to 100 % capacity: 60 min with AP 180: - up to 80 % capacity: 25 min - up to 100 % capacity: 30 min Cutting Blade Cutting length: Tooth spacing: Stroke rate: Sharpening angle to horizontal: Weight 500 mm (20 in) 33 mm (1.3 in) 3,000/min 45° without battery, with cutting blade, without blade scabbard HLA 65: HLA 85: 3.5 kg (7.7 lbs) 4.4 kg (9.7 lbs) Transporting batteries English STIHL batteries comply with the requirements set forth in UN-Manual ST/SG/AC.10/11/Rev.5/Part III, Subsection 38.3. Commercial air, vessel and ground transportation of lithium ion cells and batteries is regulated. The battery is classified as a UN3091, Class 9, packaging group 2 product. Shipping it, either as a complete tool or the battery, requires compliance with all applicable shipping regulations. Check with the ground, vessel, air cargo or passenger airline to determine if transport is prohibited or subject to restrictions or exemptions prior to shipping or travel. Normally, no further conditions have to be fulfilled by the user to transport STIHL batteries by road to the power tool's operating site. Check and comply with any special regulations that may apply to your situation. FCC 15 Compliance Statement for power tool and charger This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: - this device may not cause harmful interference. - this device must accept any interference received, including interference that may cause undesired operation. HLA 65, HLA 85 31