Stihl HLA 85 Instruction Manual - Page 9

Before Starting Work WARNING Always check your power tool for proper condition and operation before starting, particularly the trigger switch, trigger switch lockout, switch lever and retaining latch. The trigger switch, trigger switch lockout and switch lever must move freely and always spring back to the idle position (retaining latch on ,). Never attempt to modify the controls or safety devices. WARNING Your power tool is equipped with a system designed to quickly stop the cutting blades - they come to an immediate standstill as soon as you release the trigger switch and/or the switch lever on the loop handle. Check this function at regular short intervals. To reduce the risk of injury, do not operate your power tool if the cutting blades continue to run. Contact your servicing dealer. WARNING Never use a power tool that is damaged or not properly maintained. Keep the handles clean and dry at all times; it is particularly important to keep them free of moisture, pitch, oil, grease or resin in order for you to maintain a firm grip and properly control your power tool. WARNING The cutting blades must be properly tightened and in safe operating condition. Inspect for loose parts (nuts, screws, etc.) and for cracked, bent, warped or damaged blades. Regularly check the condition and tightness of the cutting blades - with the motor stopped, retaining latch on ƒ and battery removed! Replace damaged cutting blades before using the power tool. Always keep blades sharp. STIHL recommends that you always spray the cutting blades with STIHL resin solvent before starting work - with the motor stopped, retaining latch on ƒ and battery removed! You can obtain this protective spray from your dealer. Apply generously. Check contacts in battery compartment for foreign matter. Keep clean. Fit the battery correctly - it must engage audibly. For specific starting instructions, see the appropriate section of your instruction manual. WARNING To reduce the risk of injury from blade contact, be absolutely sure that the cutting blades are clear of you and all other obstructions and objects, including the ground. WARNING Your power tool is a one-person machine. Do not allow other persons in the general work area, even when starting. English During Operation Holding and Controlling the Power Tool (Version without Telescoping Shaft) Always hold the unit firmly with both hands on the handles while you are working. Wrap your fingers and thumbs around the handles. Right-Handers Right hand on the control handle and left hand on the loop handle or handle hose on the drive tube. Left-Handers Left hand on the control handle and right hand on the loop handle or handle hose on the drive tube. Make sure you have firm and secure footing and hold the unit so that the cutting blades are always away from your body. 4866BA003 KN 4866BA002 KN HLA 65, HLA 85 7