Stihl HT-KM Instruction Manual - Page 7

002BA254 KN 275BA006 KN It may be carried only in a horizontal position. Grip the shaft in a manner that the machine is balanced horizontally. Keep the hot muffler away from your body and the cutting attachment behind you. Accidental acceleration of the engine can cause the chain to rotate and cause serious injuries. WARNING When transporting it in a vehicle, properly secure it to prevent turnover, fuel spillage and damage to the unit. Before Starting Take off the chain guard (scabbard) and inspect the pole pruner for proper condition and operation. (See the maintenance chart near the end of this instruction manuals.) WARNING Always check your power tool for proper condition and operation before starting. Never attempt to modify the controls or safety devices. WARNING Never operate your power tool if it is damaged, improperly adjusted or maintained, or not completely or securely assembled. Keep the handles clean and dry at all times; it is particularly important to keep them free of moisture, pitch, oil, fuel mix, grease or resin in order for you to maintain a firm grip and properly control your power tool. For proper assembly of the bar and chain follow the procedure described in the chapter "Mounting the Bar and Chain" in this instruction manual. STIHL Oilomatic chain, guide bar and sprocket must match each other in gauge and pitch. WARNING Proper tension of the chain is extremely important. In order to avoid improper setting, the tensioning procedure must be followed as described in your manual. Always make sure the hexagonal nut(s) for the sprocket cover is (are) tightened securely after tensioning the chain in order to secure the bar. Never start the pole pruner with the sprocket cover loose. Check chain tension once more after having tightened the nut(s) and thereafter at regular intervals (whenever the pole pruner is shut off). If the chain becomes loose while cutting, shut off the engine and then tighten. Never try to adjust the chain while the engine is running! Adjust harness and hand grip to suit your size before starting work. To be better prepared in case of an emergency, practice releasing the unit from the harness as quickly as possible. Starting Start the engine at least 10 feet (3 m) from the fueling spot, outdoors only. English For specific starting instructions, see the appropriate section of your KombiEngine and KombiTool manuals. Place the pole pruner on firm ground or other solid surface in an open area or, in the alternative, as shown in the above picture. Maintain good balance and secure footing. WARNING To reduce the risk of injury from loss of control, do not attempt to "drop start" your power tool. WARNING To reduce the risk of injury from loss of control be absolutely sure that the guide bar and chain are clear of you and all other obstructions and objects, including the ground, because when the engine starts at starting-throttle, engine speed will be fast enough for the clutch to engage the sprocket and move the chain. Once the engine has started, immediately blip the throttle trigger, which should release the starting throttle and allow the engine to slow down to idle. HT-KM 5