Stihl MS 180 Product Instruction Manual - Page 54
Specifications
View all Stihl MS 180 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
English Specifications EPA / CEPA The Emission Compliance Period referred to on the Emissions Compliance Label indicates the number of operating hours for which the engine has been shown to meet Federal emission requirements. Category A = 300 hours B = 125 hours C = 50 hours CARB MS 180, MS 180 C Displacement: Bore: Stroke: Engine power to ISO 7293: Idle speed: 1.94 cu.in 31.8 cc 1.50 in 38 mm 1.1 in 28 mm 2.0 hp (1.5 kW) at 9,000 rpm 2,800 rpm Ignition System Electronic (breakerless) magneto ignition Spark plug (resistor Bosch WSR 6 F, type): NGK BPMR 7 A Electrode gap: 0.02 in 0.5 mm Fuel System The Emission Compliance Period used on the CARB-Air Index Label indicates the terms: Extended = 300 hours Intermediate = 125 hours Moderate = 50 hours Engine STIHL single cylinder two-stroke engine MS 170 Displacement: Bore: Stroke: Engine power to ISO 7293: Idle speed: 1.84 cu.in (30.1 cc) 1.45 in 37 mm 1.1 in 28 mm 1.7 hp (1.3 kW) at 8,500 rpm 2,800 rpm All position diaphragm carburetor with integral fuel pump Fuel tank capacity: 8.5 fl.oz (0.25 l) Chain Lubrication Fully automatic, speed-controlled oil pump with rotary piston Oil tank capacity: 4.9 fl.oz (0.145 l) Weight dry, without bar and chain MS 170: MS 180: MS 180 C with quick chain adjuster: MS 180 C with quick chain adjuster and Easy2Start: 8.6 lbs (3.9 kg) 8.6 lbs (3.9 kg) 8.8 lbs (4.0 kg) 9.3 lbs (4.2 kg) Cutting Attachments Recommended cutting attachments conforming with the 45 degree computed kickback angle requirement of Section 5.11 of ANSI/OPEI B175.1-2012 when used on this model chain saw (see the chapter on "Safety Precautions and Working Techniques"): Rollomatic E guide bars Reduced kickback STIHL guide bars (with green label) Bar lengths: 30, 35, 40 cm (12, 14, 16 in.) Pitch: 3/8" P(9.32 mm) Groove width (MS 170): 1.1 mm (0.043 in) Groove width (MS 180): 1.3 mm (0.050 in.) Sprocket nose: 10-tooth Actual cutting length will be less than listed bar length. 52 MS 170, MS 170 C, MS 180, MS 180 C