Stihl MS 201 T C-M Instruction Manual - Page 32

English Assembly 2 N Fasten the locking strip (2) on the cylinder fin N Turn the clutch clockwise until the piston rests against the locking strip 0011BA032 KN N Fit needle cage and chain sprocket on the crankshaft N Screw the clutch counterclockwise onto the crankshaft N Tighten the clutch with a torque of 25 Nm N Remove the locking strip from the cylinder, screw in and tighten the spark plug N Push the spark plug boot onto the spark plug 144BA017 LÄ N Loosen the hexagon of the clutch counterclockwise (left-handed thread) N Unscrew clutch Maintaining and Sharpening the Saw Chain Sawing effortlessly with a properly sharpened saw chain A properly sharpened saw chain cuts through wood effortlessly even with very little pushing. Never use a dull or damaged saw chain - this leads to increased physical strain, increased vibration load, unsatisfactory cutting results and increased wear. N Clean the saw chain N Check the saw chain for cracks and damaged rivets N Replace damaged or worn chain components and adapt these parts to the remaining parts in terms of shape and level of wear - rework accordingly Carbide-tipped (Duro) saw chains are especially wear-resistant. For an optimal sharpening result, STIHL recommends STIHL servicing dealers. N Remove chain sprocket (3) and needle cage (4) from the crankshaft N Clean crankshaft stub and needle cage and lubricate with STIHL lubricant (special accessory) 30 144BA018 LÄ Compliance with the angles and dimensions listed below is absolutely necessary. An improperly sharpened saw chain - especially depth gauges that are too low - can lead to increased kickback tendency of the chain saw - risk of injury! MS 201 T