Stihl TS 800 Instruction Manual - Page 12

English Starting WARNING Your cut-off machine is a one-person tool. Do not allow other persons to be near a running cut-off machine. Start and operate your cut-off machine without assistance. Follow the specific starting instructions, found in the chapter "Starting/Stopping the Engine" in this instruction manual. Do not drop start the cut-off machine. Drop starting means pushing the machine away from the operator, or allowing it to drop toward the ground, while pulling on the starter grip. This method is very dangerous because you may lose control of the cut-off machine. Instead, to start the cut-off machine place it on firm ground or other solid surface in an open area and hold it 002BA058 KN securely to the ground or surface. Maintain good balance and secure footing. Be absolutely sure that the cutting wheel is clear of you and all other obstructions and objects, including the ground or surface on which the machine is being started. When the engine starts, engine speed will be fast enough for the clutch to engage the belt pulley and turn the wheel. Never attempt to start the cut-off machine when the abrasive cutting wheel is in a cut. Once the engine has started, immediately blip the throttle trigger, which should release the slide control to the run position and allow the engine to slow down to idle. The abrasive cutting wheel should not rotate when the engine is idling. If the wheel does turn, adjust the carburetor to set the proper idle speed. See the chapter "Adjusting the Carburetor" in this instruction manual. If you cannot adjust the carburetor to the proper idle speed, shut the machine off and take it to an authorized STIHL servicing dealer for repair before using the cut-off machine. For complete starting information, see the chapter "Starting/Stopping the Engine" in this instruction manual. WARNING When you pull the starter grip, do not wrap the starter rope around your hand. Do not allow the grip to snap back, but guide the starter rope slowly back to permit the rope to rewind properly. Failure to follow this procedure may result in injuries to hand or fingers and may damage the starter mechanism. Important Adjustments At correct idle speed, the wheel should not turn. For directions on adjusting idle speed, see the chapter "Adjusting the Carburetor" in this manual. WARNING Do not use a cut-off machine with the idle speed incorrectly adjusted. The rotating wheel may cause injury. If you cannot obtain the correct setting, have your STIHL dealer check your cut-off machine and make proper adjustments or repairs. Working Conditions Operate the cut-off machine under good visibility and daylight conditions only. Wearing hearing protection reduces sound perception. Be alert not to miss voice or other audible signals from coworkers or supervisors. Keep within calling distance to other persons who may assist in case of emergency. 10 TS 700, TS 800