Sub-Zero 427 Sub-Zero Design Guide - Page 79
Dual Flush Inset Panels
View all Sub-Zero 427 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
Wine Storage 79 subzero.com/specs Model WS-30 DUAL FLUSH INSET PANELS When installing two models WS-30 or a model WS-30 and built-in unit side by side in a flush inset application, you must decrease the width of the decorative flush inset panels by 1/2" (13). Adjustments to the panel offsets will also need to be made. These adjustments are needed to achieve a proper fit and to ensure the panels do not collide when closing. Panel dimensions in the chart below have been adjusted to reflect the decrease in panel dimensions. IMPORTANT NOTE: If a filler strip is not used, dual installations can only be accomplished using two units with opposite hinges. Illustrations A-E provide panel offsets and reveals for model WS-30 in a flush inset application. Refer to the chart below for reference to the illustrations. All reveals are 1/2" (13) unless otherwise specified. For additional information on panel reveals, visit the specification library section of our website, subzerotrade.com. Do not exceed the flush inset decorative panel dimensions. Exceeding dimensions could cause damage to the panels and the Sub-Zero unit. Panel Offsets MODEL WS-30 Doors (hinge) / Grille Sides Doors (handle) Sides Grille Top Grille Bottom / Door Top Door Bottom Illus. A B C D E TOP VIEW DOOR / DRAWER / GRILLE BACKER SPACER CABINETRY DOOR TOP VIEW DUAL TRIM DOOR FLUSH INSET PANEL 5/16" (8) 1/2" (13) 5/8" (16) 5/16" (8) 1/8" (3) 1/4" (6) REVEAL Illus. A Illus. B CABINETRY 1/2" (13) GRILLE 1/8" 5/16" (3) (8) GRILLE DOOR Illus. C SIDE VIEW DOOR / DRAWER Illus. D 5/16" (8) 5/32" (4) 1/2" (13) 3/32" 5/16" (2) (8) SIDE VIEW 5/16" (8) SIDE VIEW 3/32" (2) Illus. E