Sub-Zero 700BFI Integrated Use & Care Guide - Page 15

Integrated Use & Care 15 subzero.com Drawer Storage DRAWER REMOVAL IMPORTANT NOTE: Before removing the top drawer from a drawer unit, you must first disconnect the control cable as shown in the illustration below. To remove a storage drawer from your integrated tall or drawer unit, pull it open until it stops. Raise the drawer front and pull out as shown in the illustration. To replace a drawer, raise the front of the drawer up and place onto the drawer slide tracks. Engage the hook at the rear of each slide with slots in the back of the drawer tub. For 36" (914) units, there are tabs on each drawer that must be positioned between the hooks. Then engage the small white pegs at the front of each drawer slide with holes at the front of the drawer tub. Reconnect the control cable. You must first disconnect the control cable before removing the top drawer of a drawer unit. REMOVABLE CRISPER COVER One lift-up crisper cover is standard with each tall and drawer refrigerator unit and the drawer combination unit. The clear-view window allows easy access and visibility of all vegetables stored in the drawer. You can easily remove this cover for cleaning with soap and water, or move it to another drawer by lifting the front edge up and pulling out from the front. Refer to the illustration below. IMPORTANT NOTE: For model 700BC(I), drawer combination unit, the removable crisper cover can only be used in the upper drawer. DRAWER DIVIDER The divider of the upper drawer is easily removed by pulling forward and sliding the back edge away from the back of the drawer. Reverse this procedure to insert the divider, as shown in the illustration below. The divider of the lower drawer is removable if there is no ice maker, but screws have to be removed to do so. For units with an ice maker, the lower divider is not removable. Control cable. Drawer removal. Crisper cover removal. Drawer divider removal.