Sub-Zero 736TFI Integrated Installation Guide - Page 13

Integrated Installation 13 subzero.com/specs Molding Installation Install the decorative white molding strips to the top and sides of the integrated unit for a finished look. The top molding strip, used on column and tall models, must be installed before the side molding can be attached. The top molding strip is held in place by double-sided velcro. The side molding strips snap into place over brackets attached to the side of the unit. Refer to the illustrations below for positioning. For installations where units are side by side, refer to dual installations on page 20. If you choose, the molding strips may be painted to match surrounding cabinetry. Follow these steps: Rough up the surface to be painted with fine grit sandpaper. Wipe with alcohol to ensure that the surface is clean and dry. Use an appliance or industrial grade, oil base, high gloss enamel paint. TOP MOLDING SIDE MOLDING Water Line Connection QUICK CONNECT WATER VALVE For units with an ice maker, the quick connect water valve and PEX tubing are located on the bottom right side of the unit. To connect the ice maker water line, attach the union fitting to the house water supply line. Pull the coiled gray PEX tubing with red cap and captured nut toward the house water supply line. Remove and discard the red cap. Then attach the tubing to the union with the nut. Tighten all connections. Recoil the excess tubing under the unit. Refer to the illustration below. Turn on the water supply and check all fittings for leaks. Make sure the electrical harness is attached to the solenoid. An in-line filter is required when water conditions have a high sediment content. The ice maker will not fill with water immediately. Allow 24 hours for proper ice production. The first container of ice should be discarded. As with any new connection, there may be impurities in the ice from the water supply line. IMPORTANT NOTE: Water lines must not be exposed to freezing temperatures. Exposure could cause damage to the unit and home. Top molding. Side molding. PEX TUBING Water line connection.