Sunbeam SCM1866-UM Instruction Manual - Page 4

FEATURES - OPERATIONS OPERATING INSTRUCTIONS Your humidifier is equipped with a technologically advanced AccuSet Plus digital Humidistat. You can set the humidifier to run continuously in manual mode or set the AccuSet Plus digital Humidistat to your desired humidity setting. The AccuSet Plus digital Humidistat will automatically turn the humidifier ON or OFF, depending on the preset comfort level. The comfort level ranges between 30% and 65% relative humidity. MANUAL MODE INSTRUCTIONS 1. Plug the humidifier into a 120V AC electrical outlet. 2. The display will show the current room humidity. NOTE: The display range is 21% - 90%. If your room humidity level falls below 21%, the unit will display 21. If your room humidity level rises above 90%, the unit will display 90. 3. To start the unit, push the MODE ( ) button twice within 3 seconds for the HIGH (3) manual setting. 4. Press the ( ) button again for the MEDIUM (2) manual setting and again for LOW (1). After the selection is made, the display will return to show the current room humidity. 5. To stop the unit, press and hold the ( ) button for two seconds, or keep pressing the button until the display reads OFF (OF). Figure 1 B C ACCUSET PLUS HUMIDISTAT INSTRUCTIONS To take advantage of the AccuSet Plus Digital Humidistat, press the MODE ( ) button until the speed is set in either the auto HIGH (A3), auto MEDIUM (A2) or auto LOW (A1) setting. Then adjust the set humidity by using the up and down buttons. Humidity will increase or decrease in increments of 5%. When the humidity level is set, the display will return to show the current room humidity. When the room humidity level rises above the set humidity, the humidifier will stop. When the humidity level drops below the set humidity, the humidifier will turn on automatically. NOTE: Allow up to 30 minutes for the filter to fully absorb water and for the unit to produce moisture. NOTE: The AccuSet Plus Humidifier has memory. This means that when you turn the unit back on, it will be at the last setting the humidifier was set at. If you do not plan to use the humidifier for two or more days, make sure any residual water is drained from the water tank, base and wick filter to prevent algae or bacteria growth. ExTENDED RUN TIME SETTING By setting your humidifier to a specific humidity level, you are actually also extending the run time. Since the unit will turn on and off to maintain the set humidity level, less water will be used than on manual setting. A D F A. Water Tank B. Carry Handle C. FilterCheckTM Indicator E D. Humidifier Housing E. Control Panel F. Humidifier Base 16 HOUR AUTO ON/OFF TIMER INSTRUCTIONS The Auto On/Off timer will allow the user two options, to set a time to turn the unit off or to set a time to turn the unit on. Auto Off Timer While the unit is running, the off timer can be activated by holding down the up and down buttons simultaneously for 2 seconds, the screen will flash 00 and the up and down arrows can be pushed to adjust the timer up to 16 hours in increments of one, once 16 hours is reached, the next push of the timer button will cycle back to 00 hours.