Sunbeam SCM1866-UM Instruction Manual - Page 5

FEATURES - OPERATIONS The Timer Light ( ) will illuminate when the Timer is set. The unit will then shut off after the timer expires (in its current setting). While the unit is running, the timer will shut off if other modes are being changed. The timer should only be deactivated if the unit is turned off. Auto On Timer While the unit is off, press the up and down buttons simultaneously for 2 seconds. The display will flash 00. The up button may then be pushed again to increase the hours to turn on (in its last setting) from 1-16 in increments of 1 hour. The unit will be turned off after the timer expires. If the unit is then turned back on, the timer will be deactivated. The Timer Light ( ) will illuminate when the timer is set. Once 16 hours is reached, the next push of the timer button will cycle back to 00 hour. NOTE: The Auto On Timer will only activate when the room humidity is below 30%. REPLACING THE FILTERS Through normal use, waterborne minerals and sediment become trapped in the wick filters. The harder your water, the greater the amount of minerals in the water, and the more often you will need to change your filter. You will be able to monitor the life of the filters in your humidifier by checking the FilterCheckTM Indicator. NOTE: After 60 minutes of use, FilterCheckTM Indicator will Figure 2 move and indicate your filters condition. New filters will register in the section reading Good filter. After frequent use of your humidifier, the FilterCheckTM Indicator will let you know when the filters need to be changed, see Figure 2. When the needle is in the CHANGE section, this means the proper amount of moisture is not getting into your air due to the excessive minerals and sediment that have become trapped on your filters. At this point, you should replace your filters. It is important to change your filters as indicated to obtain stated performance level. To replace the filter, follow the steps below: 1. Turn the unit off and disconnect from the electrical outlet. 2. Remove the tank and main housing to access the base. 3. Remove the wick holder from the base of the humidifier. 4. Remove each individual wick and discard. Do not remove rivet, replacement wicks come equipped with rivets for easy replacement. 5. Follow the weekly cleaning instructions. 6. Insert new filters into each section of the wick holder making sure the rivet attaches to the wick holder securely. 7. Do not use wicks without rivets as this will not produce the units intended output. 8. Replace the wick holder into the base and replace main housing and then tank. 9. Repeat Operating Instructions. It will take about 30 minutes for the humidifier to reach maximum output. You can purchase replacement filters (SWF65) at your local retailer, by calling 1-888-264-9669, or by visiting www.sunbeam.ca. It is recommended that a replacement filter is purchased for uninterrupted use. CLEANING AND MAINTENANCE INSTRUCTIONS Humidifiers provide comfort by adding moisture to dry, heated indoor air. To benefit most from the humidifier and avoid product misuse, follow all instructions carefully. Please note that this is an electrical appliance and requires attention when in use. In addition, if you do not follow the recommended care and maintenance guidelines, micro-organisms may be able to grow in the water within the water tank. You must routinely follow the cleaning procedures that follow in order to ensure proper, efficient operation of your humidifier. Proper maintenance and cleaning is essential to the continued performance of your unit and the avoidance of algae or bacteria build-up.