Symphonic DSC313B Owner's Manual - Page 11
SET UP FOR USE
View all Symphonic DSC313B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
SET UP FOR USE You can program the tuner to scan all the channels you receive in your area. NOTE: Channel memory programming is NOT needed when connected to a cable box or satellite box. Just select the TV/VCR channel selector to the output channel of the cable box or satellite box (Ex CH3). Then select the channel to be viewed on the Cable Box or Satellite Box. CHANNEL SET UP FOR THE FIRST TIME 1 Plug in the TV/VCR power cord Attach the smaller end of the supplied AC cord to the AC 120V connector on the back of the TV/VCR. Then, plug the other end into a standard AC outlet. NOTE: • You must disconnect the car battery cord from the TV/VCR before you use AC power. • If some digits appear in the corner of the screen, press the POWER button without unplugging the power cord. 2 Turn on the TV/VCR Press the POWER button to turn on the TV/VCR 3 Select "ENGLISH" or "ESPAÑOL" Select "ENGLISH" or "ESPAÑOL"=Spanish using the F.FWD/B or REW/s button. "[ ]" indicate the selected language. - SET UP - B LANGUAGE [ENGLISH] ESPAÑOL AUTO PRESET 4 Begin auto preset Press the PLAY/K or STOP/L button to point to "AUTO PRESET". - SET UP - LANGUAGE [ENGLISH] ESPAÑOL Then press the F.FWD/B button. B AUTO PRESET The tuner scans and memorizes all active channels in your area. NOTES: • The TV/VCR distinguishes between standard TV channels and cable channels. • If you want to play or record a video tape BEFORE presetting the tuner, you must press the MENU button on the remote control. To preset the tuner again, see "CHANNEL SET UP AGAIN" on page 13. • The TV/VCR may recognize TV channels to be CATV channels by the receiving conditions. In this case, try auto preset again in the fine receiving conditions. 5 After scanning The tuner stops on the lowest memorized channel. If you want to recall the selected channels, you can select the desired channel directly with the remote control number buttons or CHANNEL K or Lbutton. TO SELECT A DESIRED CHANNEL You can select the desires channel by using the CHANNEL K or L button or directly pressing the number buttons on the remote control. Note for using the number buttons: • When selecting cable channels which are higher than 99, press the +100 button first, then, press the last two digts. (Example: to select channel 125, first press the +100 button then press "2" and "5"). • You must proceed single-digit channel numbers with a zero (Example: 02 ... 09). - 11 - EN 0B19