TASCAM CD-A580 Owners Manual - Page 3

Model for USA This product has been designed and manufactured according to FDA regulations "title 21, CFR, chapter 1, subchapter J, based on the Radiation Control for Health and Safety Act of 1968", and is classified as class ! laser product. There is not hazardous invisible laser radiation during operation because invisible laser radiation emitted inside of this product is completely confined in the protective housings. The label required in this regulation is as follows: For U.S.A. RACK-MOUNTING THE UNIT Use the supplied rackmount screw kit to mount the unit in a standard 19-inch rack, as shown in the illustration below. Remove the feet of the unit before mounting. Model for USA Supplier's Declaration of Conformity Model number: CD-A580 Trade name: TASCAM Responsible party: TEAC AMERICA, INC. Address: 1 0410 Pioneer Blvd. Unit #1 Santa Fe Springs, California 90670, U.S.A. Telephone number: 1-323-726-0303 This device complies with Part.15 of FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Information This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the equipment and/or the receiving antenna. •Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. CAUTION Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. ATTENTION oo Leave 1U of space above the unit for ventilation. oo Allow at least 10 cm (4 in) at the rear of the unit for ventilation. Model for Canada Innovation, Science and Economic Development Canada's Compliance Statement: This Class B digital apparatus complies with Canadian ICES-003. CET APPAREIL NUMÉRIQUE DE LA CLASSE B EST CONFORME À LA NORME NMB-003 DU CANADA Model for Europe This product complies with the European Directives request, and the other Commission Regulations. Model for UK This product complies with applicable UK regulations. 3