TASCAM CD-RW4U Owners Manual - Page 10

1 - Introduction-Switching to audio mode and fingerprints, grease, etc. can cause errors in the recording process. • CD-R discs are more sensitive to the effects of heat and ultraviolet rays than ordinary CDs. It is important that they are not stored in a location where direct sunlight will fall on them, and which is away from sources of heat such as radiators or heat-generating electrical devices. • Always store CD-R discs in their "jewel cases" to avoid dirt and dust accumulating on their surfaces. • Do not put labels or protective sheets on the discs and do not use any protective coating spray. • When labeling CD-R discs, always use a soft oilbased felt-tipped pen to write the information. Never use a ball-point or hard-tipped pen, as this may cause damage to the recorded side. • Dirty discs may be cleaned using a soft dry cloth and/or a commercial CD cleaning fluid or ethyl alcohol. Do not use thinner, gasoline, benzene or LP cleaning fluid, as these will damage the disc. • If you are in any doubt as to the care and handling of a CD-R disc, read the precautions supplied with the disc, or contact the disc manufacturer directly. Never use a stabilizer, printable discs or a single adapter Using commercially available CD stabilizers or printable recordable discs with this player will damage the mechanism and cause it to malfunction. You should not use an 8cm ("single") adapter when using the CD-RW4U. NOTE Never use a disc that has had a stabilizer mounted to it. The residual adhesive may cause the disc to stick to the mechanism of the CD-RW4U. If it sticks to the mechanism, you will need a technician to get it out. Recommended media An up-to-date list of manufacturers who produce media suitable for use in the CD-RW4U can be obtained from your TASCAM dealer, or found on the TASCAM Web site at http://www.tascam.com. Switching to audio mode To switch to the audio CD recorder mode, follow the instructions below. For details of how to switch into USB mode, consult the details provided in the CDRW4U USB Operation Guide: 1 Press the MENU key (E or 7) to show MODE > XXX. 2 Use the MULTI DIAL (main unit) B or press the SKIP keys (remote control) I to change the display to MODE > AUDIO. 3 Press the MULTI DIAL (main unit) B or press the ENTER key (remote control unit) 8. The unit enters audio mode in standby, showing AUDIO MODE (dimmed). 4 Press the POWER key to enter audio mode. NOTE When the unit is in USB mode, and a USB cable is connected to a powered computer, the unit enters active USB mode. When in USB mode and an active USB connection is disconnected, the unit enters USB standby mode. Making or breaking the USB connection when the unit is in audio mode (active or standby) has no effect. Although the USB cable can be connected and disconnected from the CD-RW4U in USB mode as described above, this is not recommended, as it may cause the computer system to become unstable. In USB mode, no front panel controls are operational, except the power/standby switch and the tray open/close key. Also note that if an audio CD is being played by the unit in USB mode using the computer's CD player software, the audio will not be output from the unit's analog or digital ports. Menu operations The CD-RW4U uses menus to set various parame- ters. These are made using the MENU key on the main unit or the remote control unit (E or 7). Repeated presses of the MENU key cycle through the available menus as shown below "Default settings" on page 11. 10 TASCAM CD-RW4U