TASCAM DA-302 Owners Manual - Page 5
Introduction, 1. Configuration, 2. Memory backup, 4. Condensation, 3. Installation
View all TASCAM DA-302 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
1-1. Configuration This deck consists of the following. 1.DA-302 main unit 2.Accessories Mount screw kit RC-D302 remote control unit Owner's manual Section 1 : Introduction Rack mounting Install this deck with the provided mount screw kit as illustrated. 1-2. Memory backup AUTO ID mode, AUTO ID detection level, memo point and menu setting data are all retained in the DA-302's internal memory even when the power is turned off. 1-3. Installation and operation precautions ... Do not operate this deck when the temperature is outside the operating range of 5˚C to 35˚C. To prevent malfunctions, do not install this deck anywhere where it could be exposed to dust or subject to high humidity. ... Do not apply excessive force. This could damage the internal circuitry or the cabinet. ... Use a soft cloth (such as a silicone cloth) to clean the cabinet. If the unit is very dirty, wipe the dirt off with a cloth dipped in diluted detergent. Do not use solvents such as thinner and benzine as these can melt plastic or coated surfaces and fade characters inscribed on the panel. ... Because of improvements in design and specifications, the product shown in illustrations in this manual may differ from the actual product. Note: When mounting this deck in a rack, do not reinstall the mount screws after removing the deck's feet or you may damage PCBs or other internal components. Handle the removed feet carefully. 1-4. Condensation When you move the deck from a cold place to a warm place or use it after a sudden temperature change, condensation may occur. If this happens, leave the power on, but do not operate the deck. After one or two hours, turn the power off and then on again. For CANADA AC POWER CORD CONNECTION CAUTION : TO PREVENT ELECTRIC SHOCK MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. CORDON DE CONNEXION CA ATTENTION : POUR ÉVITER LES CHOCS ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU' AU FOND. 5