TASCAM DM-24 Downloads v. 2.10 Release Notes - Page 1

9101449300 New features in DM-24 version 2.1 Buss assignment Busses 1-8 can now be assigned to the stereo buss on the ASSIGN page, the MODULE page and also using the ASSIGN section key. Bear in mind that like EFFECT 1-2, DIGITAL IN 1-2 and ASSN RETURNS 1-4, these signals enter the stereo buss after (post) the Master Comp Insert Matrix. The result of this is that if you are compressing the stereo buss, these signals assigned to the stereo buss are not affected by the compressor. However, if the ASSIGNABLE sends and returns are used as stereo buss INSERTS, these inserts will affect the signals sent to the stereo buss. Any analog inserts used on the stereo buss will also affect these signals. 1 To assign these signals directly to the stereo buss, use POD 4 to move the cursor to ST in the upper right of the ASSIGN page. 2 Then use the SEL key of the buss, or the cursor keys or the dial to highlight the item you wish to assign and press the ENTER key. This assignment can also be made in the buss MODULE page. To assign busses 1-8 to the stereo buss using the STEREO key in assign section: 1 Select the busses 1-8 using the SEL keys. 2 Then press the STEREO key in the assign section. Busses 1-8 are assigned to the stereo buss directly (this can be confirmed on the MODULE page). Buss signals assigned to the stereo buss follow the Balance Level CENTER: 0dB setting on the OPTION-PREFERENCES page. TASCAM DM-24 Version 2.1 Release Notes 1