TASCAM IF-E100 CD-400U Network Settings Owners Manual - Page 6
Connecting to the IF-E100, IP Address, Search, Subnet Mask, Gateway, Telnet Password, Device not found
![]() |
View all TASCAM IF-E100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Connecting to the IF-E100 Connection with the IF-E100 is necessary to change its network settings using CD-400U Network Settings. 1. Connect the IF-E100 and the computer that has CD-400U Network Settings installed on the same network. NOTE ii This application can only set one unit. If multiple IF-E100 cards are connected on the same network, turn the power on only for the CD-400U with the IF-E100 that you want to set. Turn off the other CD-400U units. ii If the computer that you are using has multiple network interfaces, disable the interfaces that are not being used to connect to the IF-E100 (CD-400U). ii This software can be used even if the IP address is not set on the IF-E100 (CD-400U). (see "Disabling network interfaces that will not be used" on page 7) 2. Turn the power on for the CD-400U unit with the IF-E100 in- stalled. 3. Click the TASCAM CD-400U Network Settings icon to launch the application. An IF-E100 to be set has not been found, so "IP Address" and other fields will be blank. 4. Click the Search button to search for an IF-E100 on the network. "Working..." appears while searching. 5. The IP Address, Subnet Mask, Gateway, DNS, MAC address and Telnet Password settings are shown. The IF-E100 to be set has been found and can now be set. NOTE Is one of the following message appears, the IF-E100 has not been found properly. Check the set up, make necessary adjustments and click Search again to search for the IF-E100. Message Device not found No valid active connections Multiple devices found Meaning An IF-E100 could not be found on the network. Confirm that the CD-400U power is on and that it is connected correctly. No valid network could be found. The computer that you are using might not be properly connected to the network. Multiple IF-E100 cards were found. CD-400U Network Settings cannot connect to multiple units at the same time. Turn the power off for the other CD-400U units with IF-E100 cards installed that you do not want to set now. 6 TASCAM CD-400U Network Settings
![](/manual_guide/products/tascam-ife100-cd400u-network-settings-owners-manual-69b8952/6.png)