TASCAM US-2400 Owners Manual - Page 17

5 - Applications Panning By default, the encoders control the pan value of mono tracks in Pro Tools and/or the left channel of stereo tracks. To control the pan value of the right Transport keys The REW, F FWD, STOP, PLAY and REC keys normally control the corresponding functions in Pro Tools. They also have the following additional functions when combined with the SHIFT and F-KEY keys: • SHIFT+REW locates the playhead to the beginning of the project Transport wheel Press the SCRUB key on the US-2400 to activate the transport wheel as an audio scrub wheel in Pro Tools. When the transport wheel is used with the SHIFT key SEL keys Pressing a US-2400 SEL key alone will select that channel in Pro Tools. Holding SHIFT allows multiple selections and de-selection using the SEL keys. Holding the F-KEY while pressing a SEL key will record-enable/disable that track. Special functions The following key combinations bring up commonly-used ProTools windows: • F-KEY+AUX 1 brings up the Mix window • F-KEY+AUX 2 brings up the Edit window • F-KEY+AUX 3 toggles the Transport window • F-KEY+AUX 4 toggles the Memory Locations window • F-KEY+AUX 5 toggles the Session Setup window channel of a stereo track, press the PAN key. It flashes, indicating that right channel pan mode is active. • SHIFT+F FWD locates the playhead to the end of the project • F-KEY+PLAY toggles the Loop function (same as [Option] + [L]) • F-KEY+STOP toggles Online status (same as [Command/Ctrl] + [J]) • F-KEY+REC toggles QuickPunch (same as [Command/Ctrl] + [Shift] + [P]) in this mode, it defines a selected In/Out point in the session. When SCRUB is not enabled, the transport wheel has no function. "Double-clicking" a channel's SEL key opens the channel's naming and comments dialog in the Mac version of Pro Tools. Holding the Master SEL key while pressing any channel's SEL, MUTE or SOLO key will toggle that state on all channels. • Pressing and holding F-KEY while pressing either BANK - or BANK + changes the control surface focus by one channel in the specified direction. The US-2400's motorized faders automatically move to the correct physical positions to represent their DAW-controlled channels. • Pressing IN or OUT directly sets an In or Out point. • F-KEY+IN toggles pre-roll. • F-KEY+OUT toggles post roll. TASCAM US-2400 Owner's Manual 17