TEAC AI-2000 Owners Manual - Page 9

Troubleshooting Specifications If you experience any problems with the unit, please take a moment to look through this chart before asking for repairs. If you still have a problem, contact your dealer or TEAC customer service/technical support (stated on the back cover). No power e Check the connection to the AC outlet. Check and make sure the AC source is not a switched outlet and that, if it is, the switch is turned on. Make sure there is power to the AC outlet by plugging another item such as a lamp or fan into the outlet. Remote control doesn't work. e Press the POWER switch of the main unit to turn it on. e If the batteries are dead, change the batteries. e Within the specified range of 10m, point the remote control directly at the unit's front panel. Amplifier Section Power output 125 W + 125 W (8 Ω) 180 W + 180 W (4 Ω) Frequency response 10 Hz - 30 KHz (-0.5 dB) Signal noise ratio 102 dB (A-weighted) Total harmonic distortion 0.01 % or less Input sensitivity 280 mV/47 KΩ General Power Requirements AC 230 V 50 Hz Power Consumption (nominal 330 W Dimensions (W x H x D 435 x 154 x 403 mm Weight 14.0 kg Operating temperature 5˚C - +35˚C Operating humidity 5 % - 85 % (no condensation) Storage temperature 10˚C - +55˚C e Clear any obstacle between the remote control unit and the main unit. No sound e Check the connection to the amplifier. e Check the operation of the amplifier. Accessories Power cord x 1 Remote control x 1 AAA battery x 2 Warranty card x 1 Owner's manual x 1 e Muting is activated. Press the MUTE button. Select the correct source. e Output protection has been activated. Turn off the unit, check for possible causes (e.g. short-circuited speaker cables, connected speakers with wrong impedance) and solve the problem. Wait 5 minutes before turning on the power again. oo Design and specifications are subject to change without notice. oo Weight and dimensions are approximate. oo Illustrations may differ slightly from production models. ENGLISH 9