TEAC UD-701N Owners Manual English Francais Espanol - Page 18
Basic operation, Turn the SOURCE knob to select the input
View all TEAC UD-701N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Basic operation 1 Shift the STANDBY/ON switch to its ON position to turn the unit on. oo If a stereo amplifier is connected to this unit, always turn the amplifier on very last. 2 Minimize the volume. Minimize the volume on devices used to control the volume (this unit, the stereo amplifier or other equipment connected to this unit). 3 Press the OUTPUT button to select the connector(s) that output(s) analog audio. oo DSD data can only be played back when the input source is USB or NET (including USB flash drives) or when using DoP format digital input. oo To use NET or a USB flash drive port (front or back), install TEAC HR Streamer (free) on a smartphone or tablet, and connect it to the same network as the unit. 5 Operate the playback device. Refer to the operation manual of that device. 6 Adjust the volume. When using the line outputs When LINE OUT LEVEL is set to VARIABLE, turn this unit's VOLUME knob to adjust the volume. When LINE OUT LEVEL is set to any other setting, the volume cannot be adjusted from this unit. Use the stereo amplifier or other device connected to this unit to adjust the volume. When headphones are connected to this unit Turn this unit's VOLUME knob to adjust the volume. oo When this unit's VOLUME knob is enabled, the volume setting will be shown. NOTE oo The automatic power saving function is set to ON when shipped new from the factory (page 24). oo When DIMMER (display brightness) is set to AUTO OFF, the display will turn off when not being operated (page 24). 4 Turn the SOURCE knob to select the input source. The selected source appears on the display. oo You can also use the input selection buttons on the remote control. oo If the input signal is not a digital audio signal or is an audio signal format that is not supported by this unit, such as Dolby Digital or DTS, no audio will be output. Set the digital output of the connected device to PCM audio output. oo To play back audio files when this unit is set to USB, you must first install a dedicated driver on the computer before connecting them (page 26). 18