TP-Link Archer C20 Archer C20 V1 User Guide - Page 17
The Rear Panel
View all TP-Link Archer C20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Archer C20 AC750 Wireless Dual Band Router Note: 1. After a device is successfully added to the network by WPS function, the WPS LED will keep on for about 5 minutes and then turn off. 2. The router is set to work concurrently in 2.4GHz and 5GHz by default. If you desire to choose the working frequency, please go to 4.5 Dual Band Selection. 1.4.2 The Rear Panel Figure 1-2 Rear Panel sketch The following parts are located on the rear panel (View from left to right). WPS/Reset: Pressing this button for less than 5 seconds enables the WPS function. If your client devices, such as wireless adapters, support Wi-Fi Protected Setup, press this button to quickly establish a WPA secure connection between the client devices and the router. - 5 -
Archer C20
AC750 Wireless Dual Band Router
- 5 -
Note:
1.
After a device is successfully added to the network by WPS function, the WPS LED will keep
on for about 5 minutes and then turn off.
2.
The router is set to work concurrently in 2.4GHz and 5GHz by default. If you desire to choose
the working frequency, please go to
4.5 Dual Band Selection
.
1.4.2
The Rear Panel
Figure 1-2 Rear Panel sketch
The following parts are located on the rear panel (View from left to right).
WPS/Reset:
Pressing this button for less than 5 seconds enables the WPS function. If your client devices,
such as wireless adapters, support Wi-Fi Protected Setup, press this button to quickly
establish a WPA secure connection between the client devices and the router.