TP-Link Archer C5400X Archer C5400XUS V1 Quick Installation Guide - Page 2

LED & Button Explanation Need Help? Pulsing orange The system is starting up. Solid white The router is working normally. Solid Red No internet connection. Solid Orange The router is connected to the internet, but the Wi-Fi is off. Pulsing white The firmware is being upgraded, WPS connection is being established or the router is being reset. WPS Button Press the WPS button, and immediately press the WPS button on your client to start the WPS process. Wi-Fi button Press the Wi-Fi button to turn on or off the wireless function of your router. LED button Press the LED button to turn on or off the LEDs of your router. Q1. What should I do if I can't access the web management page? If the computer is set to a static IP, change its settings to obtain an IP address automatically. Verify that http://tplinkwifi.net is correctly entered in the web browser. Alternatively, enter http://192.168.0.1 or http://192.168.1.1 in the web browser. Use another web browser and try again. Reboot your router and try again. Disable and enable the network adapter in use. Q2. What should I do if I can't access the internet? Check if the internet is working normally by connecting a computer directly to the modem via an Ethernet cable. If it is not, contact your internet service provider. Log in to the web management page of the router, and go to the Basic > Network Map page to check whether the internet IP address is valid or not. If it is, please run the Quick Setup again; otherwise, check the hardware connection. Reboot your router and try again. For cable modem users, log in to the web management page of the router and go to Advanced > Network > Internet > MAC Clone. Select Use Current Computer MAC Address and click Save. Then reboot both the modem and the router. Q3. What should I do if the router can't be found via Bluetooth in Tether (how to reset the router)? The router's Bluetooth will be enabled for 30 minutes following a reset to factory defaults. There are two ways to reset the router: With the router powered on, use a pin to press and hold the Reset button on the back of the router until the LED blinks. Log in to the web management page of the router. Go to Advanced > System Tools > Backup & Restore, and click Factory Restore. The router will reset and restart automatically. For technical support, User Guide and other information, please visit http://www.tp-link.com/support ©2017 TP-Link 7106507832 REV 1.0.1 Quick Installation Guide AC5400 MU-MIMO Tri-Band Gaming Router C5400X