TP-Link CPE520 CPE510 V1 UG - Page 74
Ping Watch Dog
View all TP-Link CPE520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
Chapter 7 Management Tab PoE Passthrough When enabled, the device allows Power over Ethernet (PoE) power to pass from LAN0 port to LAN1 port. Enable it if you want to supply power to other passive PoE device by LAN1. Ping Watch Dog Ping Watch Dog sets the device to continuously ping a user-defined IP address (it can be the Internet gateway, for example) to check the network connectivity. If there is a connection failure then the device will automatically reboot. Ping Watch Dog is dedicated to continuously monitoring the connectivity to a specific host using the Ping tool. The Ping tool sends ICMP echo request packets to the target host and listens for ICMP echo response. If the defined number of replies is not received, the tool reboots the device. Ping Watch Dog Check the Enable box to use the function of Ping Watch Dog. IP Address To Ping Specify the IP address of the target host to which the Ping Watch Dog Utility will send ping packets. Ping Interval Enter the time interval (in seconds) between two successive ping packets. The default value is 300 seconds. Startup Delay Enter the initial time delay (in seconds) from device startup to the first ICMP echo requests sent by Ping Watch Dog. The default value is 300 seconds. The Startup Delay value should be at least 60 seconds as the device's initialization takes a considerable amount of time. Failure Count To Reboot Enter the fail count of ICMP echo request. If the device sends the specified count of ICMP echo requests to the host and none of the corresponding ICMP echo response packets is received, Ping Watch Dog will reboot the device. The default value is 3. - 71 -