TRENDnet SNMP Configuration Guide - Page 11
Factory Reset, Image Update
View all TRENDnet SNMP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
To reboot for the software setting. 2-1-2 Factory Reset This function is to set the device back to the default setting in case of the messy setting. 2-1-3 Image Update Figure (10) The section is to set the TFTP Server IP Address first, and the default address was set to "192.168.1.2". The Image File can be updated by uploading the image file from the TFTP server. (Figure 10) Note: The content of the image file will write the whole firmware of the management module, please be sure that the image file is correct.
To reboot for the software setting.
2-1-2
Factory Reset
This function is to set the device back to the default setting in case of the messy setting.
2-1-3
Image Update
Figure (10)
The section is to set the TFTP Server IP Address first, and the default address was set to
“192.168.1.2”. The Image File can be updated by uploading the image file from the
TFTP server.
(Figure 10)
Note: The content of the image file will write the whole firmware of the management module, please
be sure that the image file is correct.