TRENDnet SNMP Configuration Guide - Page 3

Con through Web browser, Configuration via Serial Port

Get TRENDnet SNMP PDF manuals and user guides View all TRENDnet SNMP manuals
Add to My Manuals
Save this manual to your list of manuals

Page 3 highlights

Configure through Web browser The Media Converter chassis system is accessible using a Web browser (IE explorer, Netscape Communications, etc.) to open up the chassis monitoring system. The default IP Address for the chassis system is "192.168.1.1", and the default Login name and password is both "root". Configuration via Serial Port The Media Converter chassis system can be accessible using a terminal or terminal emulator attached to the RS232 serial port on the Switch too. NOTE: (1) The serial port cable is attached directly with the device. (2) It needs to upgrade the Terminal Emulator due to key malfunction. 1. Locate correct DB9 serial port cable with female DB9 connector. 2. Attach the DB9 serial port female cable connector to the male DB9 serial port connector on the chassis system. 3. Attach the other end of the DB9 serial port cable to a remote workstation. 4. By default, the Switch uses the following serial port parameter values: Bits per second 57600 Stop bits 1 Data bits 8 Parity NONE Flow Control NONE

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
Configure through Web browser
The Media Converter chassis system is accessible using a Web browser (IE explorer,
Netscape Communications, etc.) to open up the chassis monitoring system. The default
IP Address for the chassis system is “192.168.1.1”, and the default Login name and
password is both “root”.
Configuration via Serial Port
The Media Converter chassis system can be accessible using a terminal or terminal
emulator attached to the RS232 serial port on the Switch too.
NOTE: (1)
The serial port cable is attached directly with the device.
(2)
It needs to upgrade the Terminal Emulator due to key malfunction.
1.
Locate correct DB9 serial port cable with female DB9 connector.
2.
Attach the DB9 serial port female cable connector to the male DB9 serial port
connector on the chassis system.
3.
Attach the other end of the DB9 serial port cable to a remote workstation.
4.
By default, the Switch uses the following serial port parameter values:
Bits per second
57600
Stop bits
1
Data bits
8
Parity
NONE
Flow Control
NONE