TRENDnet TDM-E400 User's Guide - Page 20
Step 1. Connect the ADSL cable and optional telephone., Step 2. Connect the Ethernet cable.
View all TRENDnet TDM-E400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
TDM-E400 / TDM-C400 ADSL2+ Modem Router User's Manual Figure 1. Overview of Hardware Connections Step 1. Connect the ADSL cable and optional telephone. Connect one end of the provided phone cable to the port labeled DSL on the rear panel of the device. Connect the other end to your wall phone jack. Step 2. Connect the Ethernet cable. If you are connecting a LAN to the Ethernet Modem Router , attach one end of the provided Ethernet cable to a regular hub port and the other end to the Ethernet port on the Ethernet Modem Router . If you are using the Ethernet Modem Router with a single computer or hub, you can use a "straight-through " or "crossover" Ethernet cable to attach the PC directly to the device. The crossover cable is wired differently than the cable you would use to connect to a hub. When you compare the colored wires on each end of a cable, they will be in the same sequence; on crossover cables, they will not. Contact your ISP for assistance. Step 3. Install USB software and connect the USB cable. (For Ethernet/USB Combo model only) You can attach a single computer to the device using a USB cable. The USB port is useful if you have a USB-enabled PC that does not have a network interface card for attaching to your Ethernet network. You must install software on the PC to enable communication; see Connecting a computer to the USB port on page 28. 20