TRENDnet TE100-DX4PCI Manual - Page 5
Installation
View all TRENDnet TE100-DX4PCI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Ethernet Card for PCI Section 2 Installation This section describes how to install your Ethernet hub card. Perform the following steps to install the adapter. 1. Turn off your computer and all peripherals. 2. Make a note of the cables and cords that are connected to the computer and disconnect them. 3. Remove your personal computer's cover (refer to the owner's manual of your personal computer). 4. Select any available PCI slot, and remove the slot cover. 5. Carefully install the Ethernet hub card into the ex-pansion slot by firmly pressing the card into the edge of the connector slot until the card is snugly seated in the expansion slot and fasten the retaining bracket with screw from the slot cover. 6. Reinstall your personal computer's cover and re-connect the power cord and all cables. 7. Connect the Ethernet cable to your personal computer. Note: System Requirements: A PC and BIOS that support the PCI Local Bus 5