TRENDnet TE100-DX4PCI Manual - Page 6
Configuration and Diagnostics
 |
View all TRENDnet TE100-DX4PCI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Ethernet Card forPCI Specification 2.x. Section 3 Configuration and Diagnostics Your Ethernet hub card has built-in a 100Mbps MAC interface which is automatically configured when you power-up your computer, In certain computers, however, you must modify your BIOS by entering your CMOS SETUP utility. To view the configuration parameters assigned by the BIOS, boot the computer to DOS, insert the diskette into the floppy drive and then execute the utility software EZRTS.EXE in the CONFIG directory. 6
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8 -
9 -
10 -
11
 |
 |
Ethernet Card
forPCI
6
Specification 2.x.
Section 3
Configuration and Diagnostics
Your Ethernet hub card has built-in a 100Mbps MAC
interface which is automatically configured when
you power-up your computer, In certain computers,
however, you must modify your BIOS by entering
your CMOS SETUP utility.
To view the configuration parameters assigned by
the BIOS, boot the computer to DOS,
insert the
diskette into the floppy drive and then execute the utility
software EZRTS.EXE in the CONFIG directory.