TRENDnet TE100-S4PCI Manual - Page 12

3. Insert the contact edge of the 4-Port 10/100Mbps NWay Ethernet Switch Card into the connector of any available PCI Bus Master expansion slot. Press the card firmly into the connector and ascertain that the card's contacts are fully seated in the connector. 4. Install the bracket screw that secures the card to the computer chassis. 5. Replace the computer's chassis cover. 6. Reconnect the computer's power cord, and switch computer power on. If the BIOS section of your computer boot program is Plug and Play compliant, then at power-up the BIOS will automatically configure any newly installed 4-Port 10/100Mbps NWay Ethernet Switch Card. LED Indicators Link/Activity (LINK/ACT): This LED indicator lights green when there is a secure connection (or link) to a device at the port. The LED indicators blink green whenever there is reception or transmission of data occurring at a port. 100Mbps Indicator (100Mbps): This LED indicator lights green when a 100Mbps network is connected to this port. If a 10Mbps device is connected to this port, the LED indicator is OFF. Collision/Full-duplex (COL/FDX): This LED indicator lights green when this port is in full duplex (FDX) mode. Otherwise, it is OFF for half duplex (HDX) operations. It blinks green, when collisions are occurring on this port. 8