TRENDnet TEW-411BRPplus User's Guide - Page 6

3. Hardware Installation Front Panel The front panel provides LED's for device status. Refer to the following table for the meaning of each feature. LED STATUS Description PWR/STAT Off No power Red On 1. Power on 2. Reset to default 3. Firmware upgrade (first 1 minute) Red Blink 1. System up 2. Power on 3. Firmware upgrade LAN Off no Ethernet link detected Green On 10/100Mbps Fast Ethernet link detected. No activity. Green Blink Indicates data traffic on the 10/100 Mbps LAN WAN Orange Blink Indicates data traffic on the 10/100 Mbps WAN G Yellow Indicates the device is linking or active data through wireless Blink links Rear Panel The rear panel features 4 LAN ports, 1 WAN port and Reset button. Refer to the following table for the meaning of each feature. Used to connect to the power outlet. Only use the power Power (DC 5v) adapter provided with the device. Use of an unauthorized power adapter may cause damage to your device and void your warranty. Reset Press the Reset Button for approximately ten seconds. All configurations will set to factory default settings. LAN The RJ-45 Ethernet ports are used to connect your PC, hub, switch or Ethernet network to your AP router. WAN The RJ-45 Ethernet port labeled WAN is used to connect your AP Router to your xDSL or Cable modem. AP Router Default Settings The default settings are shown following. User Name Password admin AP Router IP Address 192.168.1.1 AP Router Subnet Mask 255.255.255.0 RF ESSID wlan-g 11g RF Channel 6 Mode 11b+11g Encryption Disabled DHCP client Enabled User's Guide 5