TRENDnet TEW-800MB User's Guide - Page 10

TRENDnet User's Guide 3. Click OK and wait while changes are being applied. Setup is complete. Place the TEW-800MB in your desired location. Please refer to the "Steps to improve wireless connectivity" section on page 18 for your location placement. TEW-800MB Wi-Fi Protected Setup (WPS) 1. Power up the TEW-800MB (On/Off power switch, EU only); wait until the power LED on the front of the unit lights up. After the connection between the TEW-800MB and your router is successful, the IP address of the TEW-800MB will change to a different IP from the default, 192.168.10.110. To find out the IP assigned to the TEW-800MB from your router, please check the DHCP client (device) list on your router and then type in the assigned IP of the media bridge from your router in the browser to access to the management interface of the media bridge. You may type in the http://tew-800mb in your browser to access to the management interface of the media bridge. Press the WPS button on your router for 5 sec, then the WPS button on the TEW-800MB for another 5 sec. 2. The power button will start blinking. Installation is complete when the power LED turns solid green. Note: With the WPS installation method, the TEW800MB adopts your router's password settings and wireless encryption. In WPS mode, the TEW-800MB may connect to your router on the default 2.4GHz band. Please refer to the Manual setting of the Basic Wireless Setting section for the 5GHz band choice. © Copyright 2013 TRENDnet. All Rights Reserved. 10