Tanaka TCS33EB14 Handling Instructions - Page 8

WARNINGS AND SAFETY INSTRUCTIONS Operator safety ○ Always wear a safety face shield or goggles. ○ Gloves should be used when sharpening chain. ○ Always wear safety protective equipment such as jacket, trousers, gloves, helmet, boots with steel toe-caps and nonslip soles whenever you use a chain saw. For working in trees the safety boots must be suitable for climbing techniques. Do not wear loose clothing, jewelry, short pants, sandals or go barefoot. Secure hair so it is above shoulder length. ○ Do not operate this tool when you are tired, ill or under the influence of alcohol, drugs or medication. ○ Never let a child or inexperienced person operate the machine. ○ Wear hearing protection. Pay attention to your surroundings. Be aware of any bystanders who may be signaling a problem. Remove safety equipment immediately upon shutting off engine. ○ Wear head protection. ○ Never start or run the engine inside a closed room or building. Breathing exhaust fumes can kill. ○ For respiratory protection, wear a protection mask while emitting the chain oil mist and dust from sawdust. ○ Keep handles free of oil and fuel. ○ Keep hands away from cutting equipment. ○ Do not grab or hold the unit by the cutting equipment. ○ When the unit turned off, make sure the cutting attachment has stopped before the unit is set down. ○ When operation is prolonged, take a break from time to time so that you may avoid possible Hand-Arm Vibration Syndrome (HAVS) which is caused by vibration. ○ The operator must obey the local regulations of cutting area. WARNING ○ Antivibration systems do not guarantee that you will not sustain Hand-Arm Vibration Syndrome or carpal tunnel syndrome. Therefore, continual end regular users should monitor closely the condition of their hands and fingers. If any of the above symptoms appear, seek medical advice immediately. ○ Long or continuous exposure to high noise levels may cause permanent hearing impairment. Always wear approved hearing protection when operating a unit/machine. ○ If you are using any medical electric/electronic devices such as a pacemaker, consult your physician as well as the device manufacturer prior to operating any power equipment. Unit/machine safety ○ Inspect the entire unit/machine before each use. Replace damaged parts. Check for fuel leaks and make sure all fasteners are in place and securely tightened. ○ Replace parts that are cracked, chipped or damaged in any way before using the unit/machine. ○ Make sure the side case is properly attached. ○ Keep others away when making carburetor adjustments. ○ Use only accessories as recommended for this unit/machine by the manufacturer. ○ Never let the chain strike any obstacle. If the chain makes contact, the machine should be stopped and checked carefully. ○ Make sure the automatic oiler is working. Keep the oil tank filled with clean oil. Never let chain run dry on the bar. ○ All chain saw service, other than the items listed in the operatorʼs/ ownerʼs manual, should be performed by competent chain-saw service personnel. (For example, if improper tools are used to remove the flywheel or if an improper tool is used to hold the flywheel in order to remove the clutch, structural damage to the flywheel could occur and could subsequently cause the flywheel to burst.) WARNING ○ Never modify the unit/machine in any way. Do not use your unit/ machine for any job except that for which it is intended. ○ Never use chain saw without any safety equipment or that has faulty safety equipment. It could result in serious personal injury. ○ Using guide bar/chain other than recommended by the manufacturer which are not approved, could result in a high risk of personal accidents or injury. Fuel safety ○ Mix and pour fuel outdoors and where there are no sparks or flames. ○ Use a container approved for fuel. ○ Do not smoke or allow smoking near fuel or the unit/machine or while using the unit/machine. ○ Wipe up all fuel spills before starting engine. ○ Move at least 3 m away from fueling site before starting engine. ○ Stop engine before removing fuel cap. ○ Empty the fuel tank before storing the unit/machine. It is recommended that the fuel be emptied after each use. If fuel is left in the tank, store so fuel will not leak. ○ Store unit/machine and fuel in area where fuel vapors cannot reach sparks or open flames from water heaters, electric motors or switches, furnaces, etc. WARNING Fuel is easy to ignite or get explosion or inhale fumes, so that pay special attention when handling or filling fuel. Cutting safety ○ Do not cut any material other than wood or wooden objects. ○ For respiratory protection, wear an aerosol protection mask when cutting the wood after insecticide has been applied. ○ Keep others including children, animals, bystanders and helpers outside the hazard zone. Stop the engine immediately if you are approached. ○ Hold the unit/machine firmly with the right hand on the rear handle and the left hand on the front handle. ○ Keep firm footing and balance. Do not over-reach. ○ Keep all parts of your body away from the muffler and cutting attachment when the engine is running. ○ Keep Bar/Chain below waist level. ○ Before felling a tree, the operator must be accustomed to the sawing techniques of the chain saw. ○ Be sure to pre-plan a safe exit from a failing tree. ○ While cutting, hold saw firmly with both hands with thumb firmly locked around front handle, and stand with feet well balanced and your body balanced. ○ Stand to the side of the saw when cutting - never directly behind it. ○ Always keep the spiked bumper face to a tree, because the chain may suddenly be drawn into a tree, if so equipped. ○ When completing a cut, be ready to hold up the units as it breaks into clear, so it will not follow through and cut your legs, feet or body, or contact an obstruction. ○ Be alert against kickback (when saw kicks up and back at operator). Never cut with the nose of the bar. ○ When relocating to a new work area, be sure to shut off the machine and ensure that all cutting attachments are stopped. ○ Never place the machine on the ground when running. ○ Always ensure that the engine is shut off and any cutting attachments have completely stopped before clearing debris or removing grass from the cutting attachment. ○ Always carry a first-aid kit when operating any power equipment. ○ Never start or run the engine inside a closed room or building and/or near the inflammable liquid. Breathing exhaust fumes can kill. Maintenance safety ○ Maintain the unit/machine according to recommended procedures. ○ Disconnect the spark plug before performing maintenance except for carburetor adjustments. ○ Keep others away when making carburetor adjustments. ○ Use only genuine Tanaka replacement parts as recommended by the manufacturer. CAUTION Do not disassemble the recoil starter. You may get a possibility of personal injury with recoil spring. 8