Thermador CEM366TB Installation Instructions - Page 5
Before you begin
View all Thermador CEM366TB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Before you begin Beforyubegin Tools and parts needed ▯ Phillips Head Screwdriver ▯ Pencil ▯ Drill with ¼" (6 mm) bit ▯ Jigsaw ▯ Tape Measure Note: Additional materials may be necessary for installation in solid surface countertops. Contact the countertop manufacturer. Parts included Cabinet Requirements The distance from the top of the cooktop to the bottom of cabinets above must be a minimum of A=30" (762 mm). This distance can be reduced to A=24" (610 mm) when the bottom of the wood or metal cabinet is protected by not less than ¼" (6.35 mm) flame-retardant millboard covered with not less than no. 28 gauge sheet metal, 0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper. Verify that the cabinets above the cooktop are a maximum of B=13" (330 mm) deep. % $ Countertop Requirements 9 WARNING To reduce the risk of ignition of surrounding combustible materials, install at least 2" (51 mm) from both sidewalls and the rear wall. The countertop must be level and horizontal. The stability of the countertop must be maintained after the cut-out has been made. Solid surface countertops often require special installations. For example, heat-reflective tape and rounded corners may be necessary. Contact the countertop manufacturer for instructions specific to your countertop. 5