Thermador CEM366TB Installation Instructions - Page 8

Model: CET305TB Model: CET366TB     Electrical Installation Electrical requirements You can find the identification plate with the electrical specifications on the underside of the appliance. The junction box must be located within 3 feet of the cooktop connection. It should be easily accessible for service purposes. PP )LWWLQJ&RQGXLW DSSUR[ PP PP  PP -ER[ &RQGXLWDSSUR[ IHHWaPP Power supply Model CEM305TB CET305TB CEM366TB CET366TB 240 V AC, 60 Hz system: circuit breaker 40 Amp 40 Amp 50 Amp 50 Amp 8 208 V AC, 60 Hz system: circuit breaker 30 Amp 30 Amp 40 Amp 40 Amp Connect Electrical Supply 9 WARNING Before installing, turn off at the service panel. Lock service panel to prevent power from being turned on accidentally. The electrical power supply system should be a 1-phase, 3-wire system with ground connection. Install suitable junction box (not furnished). An appropriately-sized, ULlisted conduit connector must be used to correctly attach the conduit to the junction box. The branch-circuit breakers ampacity, the wire sizes and the connections must conform to the requirements of the National Electrical Code or Canadian Electrical Code and all local codes and ordinances. Attach flexible conduit to the junction box. Metal conduit and leads are factory installed. 9 WARNING To reduce the risk of electrical shock and fire, do not use a flexible power-supply cord with this appliance. Connect only to a 3 wire, 120/240-volt power supply; the neutral conductor is not required for the operation of the appliance. The potential at the power supply electrical connections shall be 150-volts-to-ground or less. Connect the cooktop lead wires to the junction box supply wires in proper phase: black (L1) to black red (L2) to red green or blank copper wire to ground