Thermador CIT365GM Design Guide - Induction Cooktops - Page 10

COOKTOPS - INDUCTION INSTALLATION OPTIONS INSTALLATION ABOve A BUILT-IN OveN Or WArMING DrAWer Thermador Induction Cooktops may be installed above a Thermador Single Built-in Oven. A minimum 1" air gap must be maintained between the bottom of the cooktop and the top of the oven. Thermador Cooktops may also be installed above a Thermador Warming Drawer to create a convenient cooking center. Refer to the warming drawer section for additional specifications. IMPOrTANT We strongly recommend the installation of a Thermador Ventilation System with this induction cooktop. Seal the surfaces of the cutout to make them heat resistant. This prevents the surfaces from expanding as a result of humidity. Solid surface countertops often require special installation. For example, heat reflective tape or rounded corners may be necessary. Contact the countertop manufacturer for instructions specific to your countertop. WArNING To reduce the risk of ignition of nearby combustible materials, install the countertop with a minimum distance of 2" (51 mm) from both side walls and the back wall. heAT ShIeLD The heat shield will require an additional 1" clearance below the cooktop. For safety reasons, the heat shield must be properly installed. This prevents components from overheating as a result of the recirculation of hot air from the cooktop. The heat shield is the same width as the cooktop. For shipping, it is screwed to the burner box. Once installed, the heat shield will be able to rotate freely, as shown in the illustration. Refer to the instructions packed with product for installation details. heat shield COOKTOPS 30-INCh INDUCTION Models: CIT304GB, CIT304GM 30-INCH COOkTOp AND CUTOUT DIMENSIONS Note: The work surface should be horizontal and level. The stability of the countertop should be confirmed even after making the cutout. INSTALLATION ABOVE A THERMADOR BUILT-IN OVEN Heat shield: Self positioning - 2 3/8" length, Minimum required air clearance: 1" (26 mm) 6 3/4" (172 mm) Fitting / Conduit 36" (914 mm) 4" (102 mm) 3 1/8" 4 3/16" (79mm) (106 mm) COOKTOP COUNTERTOP 3 "(76mm) SUMP 2 3/4" (70 mm) 11/16" (27 mm) OVEN 281/4" (718mm) 24 7/16" (621mm) 271/16" (687 mm) 29 1/16" (738 mm) 43/4" (121mm) TOE KICK Note: Dimensions based on standard countertop height (36" with 43/4" toe kick including base plate). The built-in oven can be installed below the induction cooktop as long as there is an air clearance of 1" between the bottom of the cooktop and the top of the oven. 1.800.735.4328 | THERMADOR.COM 109