Thermador MEDMCW31WS Installation Instructions - Page 2

Align the outer flanges with the outside of the universal brackets. Fasten with one ( 1 ) screw each into the end hole of each universal bracket. Tighten screws securely, but do not overtighten. 3. Place the speed oven or microwave unit on top of the universal connector brackets and fasten in place using three (3) screws per side. Tighten the screw securely, but do not overtighten. Note: The existing screws in the speed oven base help with alignment. When lowering the speed oven or microwave into place on the universal connector brackets, allow these screw heads to slide into the slots as shown in the illustration below. The screw nearest the front of the speed oven or microwave should slide into the base of the slope at the front of the bracket. Speed Oven Models MEDMC301WS PODMC301W MEDMCW31WS PODMCW31W 1. Remove the oven-mounted junction box cover located on the top rear of the oven. (See image below). 2. Remove the cap from the conduit access hole in the side of the oven-mounted junction box. 3. Guide the wires from the conduit cable (coming from the speed oven through the hole in the oven-mounted junction box. (See image below)). There are four wires from a speed oven. 4. Continue to the corresponding section depending on your oven type. Connecting the Speed Oven to the Lower Oven Note: When installing the combination unit, the speed oven power cable must be properly attached to the oven-mounted junction box. This must be done prior to supplying electrical power to the oven unit. A WARNING Check to be sure that no electrical power has yet been supplied to the oven. 2