Thermador SGSX365FS Design Guide - Gas Cooktops - Page 4

COOKTOPS - GAS GAS COOKTOPS PLANNING INFOrMATION MODeL OPTIONS There are two sizes of Thermador Masterpiece® Gas Cooktops to choose from-30-inch and 36-inch. 30-inch models are available with four Star Burners or five Star Burners. 36-inch models feature five Star Burners. Every model is Lp convertible by ordering SNLpkITF. Be sure to reference the correct model information in this design guide. INSTALLATION CONSIDerATIONS The information in this design guide provides key features, product dimensions, cutouts and installation specifications. Before installing a Thermador Masterpiece Gas Cooktop, be sure to verify the cutout dimensions and electrical/gas connections. Also, always consult with the installation manual packed with the product for complete details before installing. Thermador Masterpiece Gas Cooktops may be installed above a Thermador Single Built-in Oven as long as there is no contact between the bottom of the cooktop and the top of the oven. Thermador Masterpiece Gas Cooktops may also be installed above a Thermador Warming Drawer to create a convenient cooking center. Refer to the warming drawer section for additional specifications. Solid surface countertops require a special cutout size and special installation. For example, heat reflective tape or rounded corners may be necessary. Contact the countertop manufacturer for instructions specific to your countertop. veNTILATION reqUIreMeNTS We strongly recommend that a Thermador Ventilation Hood be installed with all Thermador Masterpiece Gas Cooktops. The hood must be installed according to instructions furnished with the hood. Refer to the ventilation section or www.Thermador.com for a complete selection of ventilation options, blowers, and accessories. When installing the gas cooktop with a downdraft ventilation system, provide approximately a 10 square inch opening (65cm2) in the toe kick area or other cabinet area for adequate air inlet. Refer to the downdraft ventilation section for more details. WArrANTY Limited warranty parts and labor (1 year) See page 294 for additional warranty details. DE S IGN C E R T IF IE D eLeCTrICAL AND GAS SPeCIFICATIONS Be sure your appliance is properly installed and grounded by a qualified technician. Installation, electrical and gas connections, and grounding must comply with all applicable local codes. Thermador Masterpiece Gas Cooktops are equipped with a 60-inch, 3-wire supply cord. MODeL SGS304FS SGS305FS SGSX305FS SGS365FS SGSX365FS reqUIreD CIrCUIT BreAKer 120V, 60 Hz 15 Amp 15 Amp 15 Amp 15 Amp 15 Amp Important: It is required that the cooktop be installed on a grounded, non-GFCI branch circuit. Thermador Masterpiece Gas Cooktops are shipped by the factory to operate on natural gas. They must be converted for use with propane. Verify the type of gas being used at the installation site matches the type of gas used by the appliance. If the location/job site requires conversion from natural gas to propane (Lp), order SNLpkITF. Field conversion must be done by qualified service personnel only. please refer to the Lp Conversion Instructions for further information. SUPPLY PreSSUre reqUIreMeNTS: Natural Gas - 7 inches water column (14.9 Millibars) minimum. LP (Propane Gas) -11 inches water column (27.4 Millibars) minimum. Note: The propane gas tank must be equipped with its own high pressure regulator in addition to the pressure regulator supplied with this unit. eLeCTrICAL AND GAS LOCATIONS The opening for the gas connection and electrical cord is located at the right rear of rough-in box as shown below. Opening for Gas Connection and Electrical Cord 1" CL of Cutout for 30" models: 12 15/16" (313 mm) for 36" models: 15 15/16" (389 mm) plan the installation so that the power connection is accessible from the front of the cabinet. Install a manual gas shutoff valve near the appliance. It must be easily accessible in an emergency. 1.800.735.4328 | THERMADOR.COM 113