Thermador SGSXP365TS Installation instructions - Page 5

9 IMPORTANT SAFETY INSTRUCTIONS READ AND SAVE THESE INSTRUCTIONS IMPORTANT: SAVE THESE INSTRUCTIONS FOR THE LOCAL ELECTRICAL INSPECTOR'S USE. INSTALLER: LEAVE THESE INSTRUCTIONS WITH THE UNIT FOR THE OWNER. OWNER: PLEASE RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE. WARNING When properly cared for, your new appliance has been designed to be safe and reliable. Read all instructions carefully before use. These precautions will reduce the risk of burns, electric shock, fire and injury to persons. When using kitchen appliances, basic safety precautions must be followed including those in the following pages. WARNING Do not repair, replace or remove any part of the appliance unless specifically recommended in the manuals. Improper installation, service or maintenance can cause injury or property damage. Refer to this manual for guidance. All other servicing must be done by an authorized service agency. ▯ Install a gas shutoff valve near the appliance. It must be easily accessible in an emergency. ▯ Leak testing must be conducted by the installer according to the instructions in this manual. ▯ The appliance and its individual shutoff valve must be disconnected from the gas supply piping system during any pressure testing at pressures in excess of 1/2 psi (3.5 kPa). ▯ The appliance must be isolated from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psi (3.5 kPa). ▯ The minimum supply pressure must be 1" water column above the manifold pressure printed on the data plate. ▯ The maximum supply pressure must not exceed 14.0 inches water column (34.9 Millibars). ▯ For Massachusetts installations: ▯ Installation must be performed by a qualified or licensed contractor, plumber or gas fitter qualified or licensed by the state, province or region where this appliance is being installed. ▯ Shut-off valve must be a "T" handle gas cock. ▯ Flexible gas connector must be new and not longer than 36 inches. ▯ Installer-show the owner where the gas shut-off valve is located. Propane Gas Installation ▯ The propane gas tank must be equipped with its own high pressure regulator. In addition, the regulator supplied with this unit must also be used. ▯ The appliance is shipped from the factory for use with natural gas. It must be converted for use with propane. A qualified technician or installer must do the conversion. Equipment and Usage Safety Requirements ▯ The cooktop must be used in conjunction with a suitable ventilation system. ▯ Remove all tape and packaging before using the appliance. Destroy the packaging after unpacking the appliance. Never allow children to play with packaging material. ▯ Never modify or alter the construction of the appliance. For example, do not remove panels, wire covers or screws. ▯ To eliminate the risk of burns or fire while reaching over heated surface units, cabinet storage space located above the surface units should be avoided. If cabinet storage is to be provided, the risk can be reduced by installing a hood that projects horizontally a minimum of 5 inches beyond the bottom of the cabinet. ▯ Verify that cabinets above the cooktop are a maximum of 13 inches (330mm) deep. Appliance Handling Safety CAUTION ▯ Unit is heavy and requires at least two people or proper equipment to move. ▯ Hidden surfaces may have sharp edges. Use caution when reaching behind or under appliance. 5