Thermador SGSXP365TS Installation Instructions - Page 10

Tip: Install hold down bracket without the adjusting Side View Gas Cooktop Installation screw installed. Turn hold down brackets flush with the sides of the cutout. This will help with inserting cooktop in hard-to-reach spaces. % $ Connect Gas Supply % The gas inlet to the unit is located at the right rear of the cooktop. Install the pressure regulator (supplied with unit) to & ' manifold pipe using Teflon tape on threads of manifold ( pipe. Turn to hand tighten plus 1/4 turn, not exceeding 1 * turn for alignment. To prevent possible damage to the gas pressure regulator, install it after the cooktop is in its $UURZRQWKHEDFNRI + permanent position. When the regulator is securely WKHSUHVVXUHUHJXODWRU installed on the manifold pipe, the conversion nut will be VKRZVWKHGLUHFWLRQRI - easily accessible. JDVIORZ / . $ & % Pressure Regulator A Manifold Pipe B Conversion Nut C Pressure Regulator 9 WARNING Do not attempt any adjustment of the pressure regulator, except when converting to propane. Adjustments could lead to leaks or cause incorrect gas pressure to the appliance. Gas and Electrical Location A Rough-in Cooktop Box B Arrow on Pressure Regulator C Pressure Regulator D 1/2" Female Pipe Threads E Flexible Gas Line G Power Cord (60 inches/1,524mm) H 120 Volt Receptacle J Gas Cut-off Valve K Gas Supply Line Stub-out L Floor Connect the gas supply line to the unit pressure regulator using a 1/2" flex gas line connector between manual shut-off valve and pressure regulator. Always use a new flex line. Check supply line connections for leaks using a soap solution or non-corrosive leak detection fluid. Do not use a flame of any sort. 1. Turn on gas. 2. Apply a soap solution or non-corrosive leak detection fluid to all joints and fittings in the gas connection between the shut-off valve and the cooktop. Include gas fittings and joints in the cooktop if connections may have been disturbed during installation. Bubbles appearing around fittings and connections indicate a leak. 3. If a leak appears, turn off supply line gas shut-off valve and tighten connections. 4. Retest for leaks by turning on the supply line gas shutoff valve. When leak check is complete (no bubbles appear), test is complete. 5. Wipe off all soap solution or detection fluid residue. 10