Thermador SGSXP365TS Installation Instructions - Page 12
Install Burner Grates, Check the Installation
View all Thermador SGSXP365TS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Install Burner Grates Properly position and install each burner grate according to each individual model as shown in the illustrations below. 30" SGS 9 WARNING To prevent flare-ups, properly support pots and avoid spills, all grates must be properly positioned on the cooktop whenever the cooktop is in use. Each of the four feet must be placed into the corresponding dimples in the cooktop. Do not use a grate if the rubber feet are missing or damaged. 30" SGSP 36" SGSX For replacement of rubber feet: Call Customer Support at 1-800-735-4328. Check the Installation Place each correct sized burner cap in its seated, notched position and check the operation of the electric igniters. Check flame characteristics. Flame should be blue with a minimal yellow tip on the outer cone of the flames. Checking Flame Characteristics Yellow Flames: Further adjustment is required. Yellow Tips on Outer Cones: Normal for LP Gas Soft Blue Flames: Normal for Natural Gas Note: If the flame is completely or mostly yellow, verify that the regulator is set for the correct fuel. After adjustment, retest. Some yellow streaking is normal during the initial startup. Allow unit to operate 4-5 minutes and re-evaluate before making adjustments. 36" SGSXP 12