Thermador T36BT810NS Installation Manual - Page 10
Required accessories and tools
View all Thermador T36BT810NS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Required accessories and tools Supplied accessories Installation instructions Operating instructions Installation kit Optional accessories Heater Kit for Side-by-Side installation XHEATKIT10 If the gap between the appliances is less than 6" (160 mm). Other required accessories Ice maker installation kit 1/4" OD copper line For connecting appliances which require water, e.g. for an ice maker. Maximum outer diameter of the water pipe (without fittings): 3/8" (9.5 mm). Other Stepladder Dolly, hand truck Hammer drill for drilling holes in wall or floor Bits according suitable for material and in different sizes Wooden beam (cross section min. 3" x 4") as an alternative tilt protection, length according to the width of the installation cavity Wooden screws in different sizes Thin (max. protect the 1fl/o1o6r" (1.5 mm)), suitable material from damage (e.g. lino) to Suitable material for covering and protecting furniture (e.g. protective sheets) Adhesive tape Note: Before using, check whether the removed adhesive tape leaves adhesive residue on the work surfaces! Otherwise do not use on high-quality work surfaces. Tools Cordless screwdriver Torx bit T20 and T30 + magnetic holder Torx screwdriver T20 5/16" (8 mm) hex nut driver Wood drills in different sizes Open end wrench 1/2" (Width across flats 13 mm) Multigrip pliers Adjustable wrench Cutter with adjustable blade Metal tape measure, folding rule Square Level, length 2' (60 cm) and 4' (1,2 m) 10